Device can't be found by Workbench
Answer
5/13/19 11:39 AM

I have just installed the Workbench, have plugged in the XDK Bosch into my computer but it seems like the Workbench isn't able to find the device. Currently, the most left button shows a green light, the most right button shows a red light. The two middle lights are off.

Can someone help me out with this one?

0 (0 Votes)
RE: Device can't be found by Workbench
Answer
5/13/19 11:46 AM as a reply to Murat Yilmaz.
An also, the green light just turned off.
0 (0 Votes)
RE: Device can't be found by Workbench
Answer
5/14/19 6:26 AM as a reply to Murat Yilmaz.

Hi Murat

Try the following things:

1. Try to refresh the devices available as shown in the below image.

2. Check whether the COM PORT is not used by any other application eg:Teraterm , HTerm etc

3.Try restaring your PC

4. Check whether the device is visible in Device Manager --> PORTS. If not visible then try flashing the bootloader and go to bootloader mode by truning on the device and pressing button 1.

Hope this helps

Thanks

Priyashi

0 (0 Votes)
RE: Device can't be found by Workbench
Answer
5/14/19 8:42 AM as a reply to Priyashi Yadav.
The problem was that my cable was broken... :/ It works now. Thanks for your help!
0 (0 Votes)