XDK Demo SensorDataOverUsb
Answer
2/4/16 12:30 PM
In the demo SendVirtualSensorDataOverUsb I wanted to print the calibrated sensor values. I can build it correctly but it takes a long time till I can see the values in the console and the orange LED is blinking the whole time. Why it takes so much time?
0 (0 Votes)
XDK Demo SensorDataOverUsb
Answer
2/4/16 1:42 PM as a reply to Ludger Bredenstein.
I have tried the demo SendVirtualSensorDataOverUsb too and it takes more then 10sec. After I change some printf-commands and start flashing, the connection broken. now, i can only charge the XDK (green LED). When i switch on the red LED flash for 1 sec. No connection anymore. 
0 (0 Votes)
XDK Demo SensorDataOverUsb
Answer
2/4/16 1:45 PM as a reply to Benedikt Euen.
hello !
Since a few minutes I have the same problem. I flashed it again and now he couldn´t connect anymore
 
0 (0 Votes)
XDK Demo SensorDataOverUsb
Answer
2/4/16 1:55 PM as a reply to Ludger Bredenstein.
Hi,

the application is running on the XDK and will be flashed over USB after building.
During flashing, the blinking orange led indicates this process.

The duration of flashing depends on the size of the XDK-application and is limited by the speed of the serial connection.
I’m really sorry for that, but the flashing speed can’t be accelerated.

The red LED indicates that the XDK is in bootloader mode. After loading the flashed application the LED turns off.

If no connection can be established, you can turn it off, and restart it with button 1 pressed.
Afterwards the XDK is in bootloader mode and you should be able to reflash it.

Kind regards,
Manuel
0 (0 Votes)
XDK Demo SensorDataOverUsb
Answer
2/5/16 7:16 AM as a reply to Manuel Cerny.
Thanks Manuel,

Kind regards, 
Bene
 
0 (0 Votes)