Community news, upcoming events and general discussions
Threads: 36 Posts: 88
Get technical support from the community
Threads: 1416 Posts: 7560
Threads: 18 Posts: 64
Tell us how to make XDK better!
Threads: 36 Posts: 119
Share and discuss community member projects
Threads: 78 Posts: 343
Hello - we have made a very good mqtt solution to connect the XDK in a very easy way to our smarthome application, also transmitting sensor data to my IPhone via my particle photons.
Next milestone is to connect external sensors, actors to the XDK gateway - also the easy way and controll and call them the same way as already - via mqtt calls and answers. Idea is to implement virtual sensors - digital and analog - which provide only their status in the mqtt answer. We have made first test with a bunch of sensors (see picture) - looks fine and works. (Hall Sensor, Flammen Sensor, Gas Sensor, Quecksilber Schalter, Gabellichtschranke, Fotowiderstand, Reedschalter, Neigungsschalter, IR Hindernis Vermeidungssensor, Regentropfen Erkennungssensor, Moisture Sensor etc.)
On the picture you see first trials without a voltage divider and a mercury sensor - but this may damage the xdk over time. Some sensors work perfekt with only the 2.5V supply.
Which problem are you solving with your solution? XDK can publish now 2 virtual analog sensor and 2 virtual digital sensor data via MQTT. (The inbuild sensors also ...) No extra software needed on the XDK - only wire up and run...
How does your idea work on the software side? The XDK sends his sensor data via MQTT to the broker only if he gets an request. Pressing the button on the XDK will start sending data automaticly. Any other software application can now work with this data. How does your idea work on the hardware side? XDK is a stand alone sensor node, can be placed where ever you want - must be in reach of your wifi network. Up to 4 sensors (2 analog, 2 digital) can wired to the xdk gateway. We have an mqtt broker (raspberrypi) who receives the messages.
Here a snapshot of an mqtt message - external sensor data last entries
Device: XDK110 Name: 20C38FF5ECD7 Timestamp: 456 acc (mG): x = +14 y = +26 z = +1014 gyro (mdeg/s): x = -5249 y = +2197 z = +4150 mag (uT): x = +3 y = +28 z = +18 light (mLux) = 43200 temp (mCelsius) = 28320 pressure (Pascal) = 98458 humidity (%rh) = 46 PA1 Input = 0 PE2 Input = 1 ADC Ch5 = 4008 ADC Ch6 = 3884
- actually testing with some nice garden sensors - see XDK powered by Solar LiPo - connected with gateway - gateway connected with 3 external sensors - data transfer via mqtt to SmartSensor Application or SmartHome Application
Hello Achim, thank you for submitting your XDK use case! You accepted the BCDS terms and conditions correctly and your idea Virtual sensors will participate in the Ideation Jam. Kind regards, Manuel